Recent questions tagged tom

0 votes

0 answers

the mechanism used in shaping machine

asked Nov 3, 2017 by niyaz1708 (120 points)

0 votes

0 answers

Determine the horizontal distance covered until the particle reached a point 30 m below its original elevation.

asked Oct 27, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Determine the stiffness of the spring and the maximum speed of the governor.

asked Oct 27, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Discuss criteria of stability for spring controlled governors.

asked Oct 27, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Presume that all masses including the balance mass rotate in the same plane.

asked Oct 27, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Define interference in involute gears.

asked Oct 27, 2017 in TOM by chandu (215k points)

0 votes

0 answers

State the factor affecting the amount of draught produced in the boiler

asked Oct 26, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Draw a self explanatory sketch of a Sigma mechanical comparator.

asked Oct 26, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Draw the free body diagram of the driven gear and show all the forces acting on it.

asked Oct 26, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Compare the deflection of the shaft at 1500 rpm in the two cases.

asked Oct 26, 2017 in TOM by chandu (215k points)

0 votes

0 answers

State the main disadvantage of this type follower motion.

asked Oct 26, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Find out balancing condition of the engine for primary and secondary effects.

asked Oct 26, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Which type of epicyclic gear train is used for rear wheel drive of automotive trucks?

asked Oct 24, 2017 in TOM by chandu (215k points)

0 votes

0 answers

What is a quick-return mechanism?

asked Oct 24, 2017 in TOM by chandu (215k points)

0 votes

0 answers

What is the difference between centrifugal and inertia type of governors?

asked Oct 24, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The surface of a nut moving over a threaded bolt?

asked Oct 24, 2017 in TOM by chandu (215k points)

0 votes

1 answer

Velocity and acceleration of sliding of bar through the swivel

asked Oct 23, 2017 in TOM by chandu (215k points)

0 votes

1 answer

Determine the (i) stiffness of each spring (ii) dynamic force transmitted to the floor

asked Oct 23, 2017 in TOM by chandu (215k points)

0 votes

0 answers

why flywheels of multi-cylinder inline engines are relatively smaller than that of single cylinder engine?

asked Oct 23, 2017 in TOM by chandu (215k points)

0 votes

1 answer

Determine the stiffness of the spring and the maximum speed of the governor.

asked Oct 23, 2017 in TOM by chandu (215k points)

Page:

« prev
1
...
28
29
30
31
32
33
34
35
36
...
50
next »

...