Recent questions tagged som

0 votes

0 answers

The equivalent spring stiffness of this new arrangement is equal to

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The stress in the copper rod is

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The magnitude of load P required to fill up the gap of 0.75 mm is:

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

When a thick plate is subjected to external loads:

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The Young’s modulus of the material is E. The extension caused by an axial load P is

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

A prismatic bar, as shown in figure is supported between rigid supports. The support reactions will be

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

A state of plane strain always results in plane stress conditions

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

A plane state of stress always results in

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

A plane state of stress always results in

asked Dec 26, 2017 in som by chandu (215k points)

+1 vote

0 answers

Which one of the following is not a statically indeterminate structure?

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

Which one of the following expresses the total elongation of

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

What is the ratio of elongation of the bar A to that of the bar B?

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

In a tensile test, near the elastic limit zone

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The elongation of the bar due to self weight is:

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

What is the approximate error in computed elongation?

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

Determine the reactions at the ends.

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

A load P is applied as shown in the figure

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The stress developed in the direction of thickness is

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

If permissible stress in plates of joint through a pin as shown in the figure is 200 Mpa then the width will be

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The elongation produced in the bar will be

asked Dec 26, 2017 in som by chandu (215k points)

Page:

« prev
1
...
15
16
17
18
19
20
21
22
23
...
35
next »

...