Recent questions tagged md

0 votes

0 answers

The bolts are subjected to

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

An eccentrically loaded riveted joint is shown with 4 rivets at P, Q, R and S.

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The bolts in a rigid flanged coupling connecting two shats transmitting power are subjected to

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In a fillet welded joint, the weakest area of the weld is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following stresses are associated with the tightening of nut on a bolt.

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In a boiler shell with riveted construction, the longitudinal seam is jointed by butt joint.

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Reynold’s equation &Lewis form factor

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The following the figures shows welded joints (xxx indicates welds), for the same load same dimension plate and weld

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

An eccentrically loaded riveted joint is shown with 4 rivets at P,Q,R and S Which of the rivets are the most loaded?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Type of joints) List – II (Mode of connecting member)

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Applications) with List – II (Joints)

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

For the bracket bolted as shown in the above figure, the bolts will develop

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

A screw thread specified by

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In pre – loaded bolted joints, there is a tendency for failure to occur in

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

If permissible stress in plates of joint through a pin as shown in the given figure is 200MPa, then the width w will be

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

For longitudinal joint in boiler, the type of joint used is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following stresses are associated with tightening of nut on a bolt

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

1 answer

The piston rod and the crosshead in a steam engine are usually connected by means of

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

When subjected to a pulling force ‘F’, the stress induced in the weld will be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The rivet head used for boiler plate riveting is usually

asked Dec 19, 2017 in md by chandu (215k points)

Page:

« prev
1
...
14
15
16
17
18
19
20
21
22
...
32
next »

...