Recent questions tagged im&or

0 votes

0 answers

The advantages of flow – line layout in a manufacturing operation are

asked Oct 4, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

To meet short range changes in demand of a product, which of the following strategies can be considered?

asked Oct 3, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Which of the following represents this activity on the flow process chart?

asked Oct 2, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

In which of the following operations micro motion study technique is used?

asked Oct 2, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Which one of the following is the correct definition of critical ratio in scheduling?

asked Oct 2, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

In designing a plant layout, a “Product Layout” should be preferred if

asked Oct 1, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Using Vogel's Approximation determine initial feasible solution. Give all assumptions and provide clear steps.

asked Oct 1, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

JIT Toyata Production System (TPS) and lean operations sustain competitive advantage.

asked Oct 1, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Determine the trial limits and revised control limits for a u-chart

asked Oct 1, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Determine the trial central line and control limits for a p-chart using the following data

asked Oct 1, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Why is Total Quality Management (TQM) important?

asked Oct 1, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Determine annual break-even point and develop break-even graph.

asked Oct 1, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Compare 'Work Sampling' with 'Time Study'.

asked Oct 1, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Cost Accounting & Depreciation

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

the maximum allowable deviation (in mm) from the target is

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Reliability of the system

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The sample mean time of any work element to be within 0.1 minutes of its true mean time with 95% confidence is

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The upper three-sigma (3$\sigma$) control limit for the proportion of defective items in any sample is __________

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The lower and upper control limits set for the p-chart should, respectively, be

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Alternative I is cheaper compared to alternative II when the demand is

asked Sep 9, 2017 in IM&OR by chandu (215k points)

Page:

« prev
1
...
35
36
37
38
39
40
41
42
43
...
52
next »

...