Recent questions tagged ies-objectives-2

0 votes

0 answers

Chip equivalent is increased by

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

If the diameter of the hole is subject to considerable variation, then for locating in

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List – I (Task) with List – II (Recommendation)

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

While cutting helical gears on a non – differential gear hobber, the feed change gear ratio is

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In a mechanical shaper, the length of stroke is increased by

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In a Swiss – type automatic lathe, the turret is given longitudinal feed for each tool in a specific order with

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Soft material cannot be economically grounded due to

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In the grinding wheel of A60 G7 B23, B stands for

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In a milling operation two side milling cutters are

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Up milling or climb is commonly used for

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The effects of setting a boring tool above centre height leads to a/an

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The primary tool force used in calculating the total power consumption in machining is the

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following work materials:

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Crater wear is predominant in

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The straight grades of cemented carbide cutting tool material contain

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statements about nose radius

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Single point theread cutting tool should ideally have

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The angle between the face and the flank of the single point cutting tool is known as

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

A chip breaker is employed to improve the machinability of

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Non – ferrous material are best machined with diamond tools.

asked Dec 23, 2017 in production by chandu (215k points)

Recent questions tagged ies-objectives-2

Categories

Most popular tags