Recent questions tagged iasprelims

0 votes

0 answers

relation between the variation of pressure and volume at constant temperature

asked Aug 31, 2017 in TD by chandu (215k points)

0 votes

0 answers

Engine components and their measuring Devices

asked Aug 31, 2017 in IC-engines by chandu (215k points)

0 votes

0 answers

Work done in a free expansion process

asked Aug 31, 2017 in TD by chandu (215k points)

0 votes

0 answers

minimum number of work stations needed for a work shift

asked Aug 31, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Johnson’s rule is applicable for

asked Aug 30, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Limitations of Process layout

asked Aug 30, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Standard times (ST) and labour rates are given then the total cost of production is?

asked Aug 30, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

asked Aug 30, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Time estimates of a project activity

asked Aug 30, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The behaviour of a bimetallic strip when heated

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

By conjugate beam method, the slope at any section of a beam is?

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Sectional modulus of a pipe

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

The equivalent bending moment of a shaft

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Percentage change in volume of a thin cylinder under internal pressure

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Stiffness, if the number of turns in a spring are halved

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Cast iron specimen in a torsion test gives

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

Alloying elements for tool steel and its improved mechanical property

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

Causes of tool wear

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

time taken for reducing the diameter by turning on a lathe

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

The amount of offset of tail stock for turning taper

asked Aug 30, 2017 in production by chandu (215k points)

Page:

« prev
1
...
40
41
42
43
44
45
46
47
48
...
63
next »

...