Recent questions tagged ht

0 votes

0 answers

Addition of further insulation of the same material will

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

Then the design thickness (in meter) of the wall to maintain a steady heat flux of 2500 W/m2 should be _____

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The interface temperature Ti (in K) of the composite wall is _____________

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The thermal conductivity (k, in W/m.K) of material P is ___

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The outer surface temperature of the fuel element would be

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

Assuming negligible contact resistance between the wall surfaces, the interface temp T(C) of the two walls will be

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The value of $\partial T/\partial X$ and $\partial T/\partial y$ P at surface are

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

Assuming the face PQRS to be at uniform temperature, its steady state temp is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The minimum thickness (m) of wall required to prevent condensation is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The thermal resistance (K/W) per unit length of the cylinder is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

With an increase in the thickness of insulation around a circular pipe, heat loss to surroundings due to

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

Room temp at the end of 24 hours will be

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The overall thermal resistance in K/W is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The heat transfer rate per unit length is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The location of maximum temp within the plate from left face is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The value of the temperature gradient in the glass at the water-glass interface in K/m is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The optimum thickness of enamel paint should be

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

which one of the following statements holds?

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

Maximum heat dissipation occurs when thickness of insulation is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

Maximum heat dissipation occurs when thickness of insulation is

asked Sep 11, 2017 in HT by chandu (215k points)

Page:

« prev
1
...
11
12
13
14
15
16
17
18
next »

...