Recent questions tagged bolted-joints&welded&riveted-joints

0 votes

0 answers

If permissible stress in plates of joint through a pin as shown in the given figure is 200MPa, then the width w will be

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

For longitudinal joint in boiler, the type of joint used is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following stresses are associated with tightening of nut on a bolt

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

1 answer

The piston rod and the crosshead in a steam engine are usually connected by means of

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

When subjected to a pulling force ‘F’, the stress induced in the weld will be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The rivet head used for boiler plate riveting is usually

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

When a nut is tightened by placing a washer below it the bolt will be subjected to

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

In the welded joint shown in the given figure if the weld at B has thicker fillets than at

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The average tensile stress in the weld is given by

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The shear stress in the weld is given by

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The tension in the bolt after this is

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

When the coupler of a turn buckle is turned in one direction both the connecting rods m

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

For bolts of uniform strength, the shank diameter is made equal to

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The allowable shearing load on per cm length of the weld is

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding power screws:

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Uniform strength bolts are used for resisting impact loads

asked Dec 19, 2017 in md by chandu (215k points)

Page:

« prev
1
2
3

...