Recent questions tagged 2011

0 votes

0 answers

Hot chamber machine is used for

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

The relationship between total freezing time ‘t’ volume of the casting v and its surface area ‘A’

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

(a) Unwin’s formula (b) Wahl factor (c) Reynold’s equation (d) Lewis form factor

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The stiffness ratio of S1 and S2 is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following statements pertaining to V belts in power transmission

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The centrifugal in a belt is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

A rope has been designated as 6x9. The numbers 6 and 19 respectively stand for

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The effect of increasing the stiffness of springs of centrifugal clutch is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The number of pairs contact surface is.

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Bending stress is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The coefficient of friction µ will change as

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

An axle is a machine part that is subjected to

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

When a journal rotates in anticlockwise direction at high speed in a bearing having adequate

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Antifriction bearings are normally used in shafts

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In a bolt of uniform strength

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The average shear stress on the throat area is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

A compound fillet welded joint loaded by P, is shown below. The maximum shearing stress occurs at point

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Large field guns, which come to initial position after firing in shortest possible time, are

asked Dec 18, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements. Transmissibility of vibrations:

asked Dec 18, 2017 in tom by chandu (215k points)

0 votes

0 answers

Rayleigh’s method of computing the fundamental natural frequency is based on

asked Dec 18, 2017 in tom by chandu (215k points)

Page:

« prev
1
...
6
7
8
9
10
11
12
13
14
...
20
next »

...