Recent questions tagged 2009

0 votes

0 answers

vertical deflection at the point of application of load

asked Aug 19, 2017 in SOM by chandu (215k points)

0 votes

0 answers

Damping factor and damped natural frequency of a vehicular suspension system

asked Aug 15, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Engine speed of an automobile supported by springs

asked Aug 15, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The critical speed of the shaft in a rotor-shaft system

asked Aug 15, 2017 in TOM by chandu (215k points)

0 votes

0 answers

magnitude of maximum stress

asked Aug 15, 2017 in SOM by chandu (215k points)

0 votes

0 answers

Match the below

asked Aug 14, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Match the below

asked Aug 14, 2017 in TOM by chandu (215k points)

0 votes

0 answers

An epicyclic gear

asked Aug 14, 2017 in TOM by chandu (215k points)

0 votes

0 answers

find out the distance between crank centre to lever centre point

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

calculation of shear angle and chip velocity in an orthogonal operation

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

calculating value of index in Taylor's tool life equation

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

calculation of cutting tool life Vs Cutting speed

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

1 answer

Diamond cutting tools are not recommended for machining of ferrous metal due to

asked Aug 11, 2017 by chandu (215k points)

0 votes

0 answers

minimum shear strain in orthogonal turning with zero rake angle is

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

Friction at the tool – chip interface can be reduced by

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

calculate heat used for producing weld nugget and heat dissipated from base metal

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

Calculation of heat input in autogeneous gas tungsten arc welding

asked Aug 9, 2017 in production by chandu (215k points)

0 votes

0 answers

ratio of solidification time of cylinder and cube

asked Aug 6, 2017 in production by chandu (215k points)

0 votes

0 answers

match the parts used in casting and their purpose

asked Aug 6, 2017 in production by chandu (215k points)

0 votes

0 answers

Volume of the metal compensated from the riser of a cubical casting

asked Aug 6, 2017 in production by chandu (215k points)

Recent questions tagged 2009

Categories

Most popular tags