Recent questions tagged 2007

0 votes

0 answers

In meshing gears with involutes gear teeth, the contact begins at the intersection of the

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Interference between the teeth of two meshing involutes gears can be reduced or eliminated by:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The ratio of the speeds of the flywheel at the beginning and the end is which one of the following?

asked Dec 13, 2017 in tom by chandu (215k points)

0 votes

0 answers

In a slider-bar mechanism, when does the connecting rod have zero angular velocity?

asked Dec 13, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which one of the following is the correct sequence of the above in the descending order of maximum velocity ?

asked Dec 1, 2017 in tom by chandu (215k points)

0 votes

0 answers

The type of cam used in cam shaft of IC engines of specified contour or specified motion.

asked Nov 27, 2017 in tom by chandu (215k points)

0 votes

0 answers

A six cylinder 4 stroke multicylinder in line engine is completely balanced in respect of reciprocating masses.

asked Nov 26, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine the change in the dynamic amplitude.

asked Nov 26, 2017 in tom by chandu (215k points)

0 votes

0 answers

Mention two best reasons why accelerometer is preferred over seismometer to measure vibration in mechanical system?

asked Nov 26, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine the minimum amount of stubbing of gear teeth in terms of module which is to be done now for this pinion.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Evaluate radius of gyration of the connecting rod about an axis

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

What is the value of Euler’s buckling load

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

What is the combined stiffness provided by these two springs in the modified arrangement?

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

What percent saving in weight would be obtained if this shaft

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the greatest central load the beam

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

What are the magnitudes of these stresses?

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

State any four basic elements of a Robot. Give one line statement for each.

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

Find the die load at the end of compression to a height of 30 mm, using slab method of analysis.

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

Why parting plane is provided, in closed die forging?

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

What is the principle of resistance welding?

asked Nov 19, 2017 in production by chandu (215k points)

Recent questions tagged 2007

Categories

Most popular tags