Recent questions tagged 2003

0 votes

0 answers

Define contact ratio of two mating gears and mention its importance in design of gear drive.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine the angular acceleration of connecting rod and total acceleration of its midpoint.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

State what is meant by kinematic inversion of a mechanism.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Find the radial pressure between the rod and the casing,

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Find the slope and deflection at the free end of a cantilever beam of length 6m as loaded shown in figure

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Find the power being transmitted by the shaft.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Estimate the axial stresses in the bolt and the tube before and after heating.

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

How is the Poisson’s ratio related to these modulii?

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

How fine through holes of diameter less than 50 microns can be made in 1.0 mm thick aluminium sheets?

asked Nov 21, 2017 in production by chandu (215k points)

0 votes

0 answers

Mention the major essential components of any Flexible Manufacturing System (FMS) used for production by machining.

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

What is meant by Basic Length Unit (BLU) of CNC machine tools?

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

What will be the “length of contact “with the rolls?

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

Determine: (i) extrusion ratio (ii) true strain (homogeneous deformation)

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

How is “Bend Allowance” (BA) calculated in sheet metal working?

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

What would be the proportion of heat energy utilized for welding

asked Nov 19, 2017 in production by chandu (215k points)

0 votes

0 answers

Compare the solidification time of two optimum side-risers of the same volume

asked Nov 17, 2017 in production by chandu (215k points)

0 votes

0 answers

If the mean rolling pressure is 500 MPa, what is the total rolling load?

asked Nov 17, 2017 in production by chandu (215k points)

0 votes

0 answers

Name the processes by which external screw thread can be produced (both manually using tools and in machines).

asked Nov 17, 2017 in production by chandu (215k points)

0 votes

0 answers

For the above machining condition determine the values of

asked Nov 16, 2017 in production by chandu (215k points)

0 votes

0 answers

what will be the effect of increasing the diameter of the straight fluted plain milling cutter

asked Nov 16, 2017 in production by chandu (215k points)

Page:

« prev
1
...
7
8
9
10
11
12
13
14
15
...
22
next »

...