Recent questions tagged 1997

0 votes

0 answers

When a shaft transmits power through gears, the shaft experiences

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In the welded joint shown in the given figure if the weld at B has thicker fillets than at

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The average tensile stress in the weld is given by

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Failure theories) with List – II (Figures representing boundaries of these theories)

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The equivalent length of the shaft is equal to

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

Shown in the figure then the resulting deflection will be given by

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

The phase angle between them then the vectors C and D represent respectively.

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which is the equivalent stiffness

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

A damped free vibration is expressed by the general equation

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List – I with List – II and select the correct answer using the codes given below the lists

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

Accelaration due to gravity the height

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The sensitivity of an isochronous governor is

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The degree of hunting with an unsable governor will be less than that with an isochronous governor

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The total dynamic reactions at the supports will be

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The secondary reverse crank for balancing will be at

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

If the arm C makes three revolutions the number of revolutions made by B will be

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

In the case of an involute toothed gear involute starts from

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

A reverted gear train is one in which the output shaft and input shaft

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List – I (Positioning of two shafts) with List – II (Possible connection)

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

What is the correct sequence of the following steps in engine analysis?

asked Dec 13, 2017 in tom by chandu (215k points)

Page:

« prev
1
...
5
6
7
8
9
10
11
12
13
...
15
next »

...