Recent questions tagged 1995

0 votes

0 answers

Among these, the factors which are to be considered while developing a good wage incentive plan would include

asked Dec 29, 2017 in im&or by chandu (215k points)

0 votes

0 answers

Which one of the following methods can be used for forecasting the sales potential of a new product?

asked Dec 29, 2017 in im&or by chandu (215k points)

0 votes

0 answers

Match List – I (Alloy) with List – II (Use)

asked Dec 29, 2017 in material science by chandu (215k points)

0 votes

0 answers

The structure of a polymer is shown in the given figure. This polymer finds special application in

asked Dec 29, 2017 in material science by chandu (215k points)

0 votes

0 answers

In low carbon steels, presence of small quantities sulphur improves

asked Dec 29, 2017 in material science by chandu (215k points)

0 votes

0 answers

Match List – I (Heat treatment) with List – II (Effect on the properties)

asked Dec 28, 2017 in material science by chandu (215k points)

0 votes

0 answers

Addition of magnesium to cast iron increases its

asked Dec 28, 2017 in material science by chandu (215k points)

0 votes

0 answers

Which one of the following sets of constituents is expected in equilibrium cooling of a hypereutectoid steel

asked Dec 28, 2017 in material science by chandu (215k points)

0 votes

0 answers

Match List – I (Name of material) with List – II (% Carbon range)

asked Dec 27, 2017 in material science by chandu (215k points)

0 votes

0 answers

Eutectoid reaction occurs at

asked Dec 27, 2017 in material science by chandu (215k points)

0 votes

0 answers

Addition of silicon cast iron

asked Dec 27, 2017 in material science by chandu (215k points)

0 votes

0 answers

Addition of silicon cast iron

asked Dec 27, 2017 in material science by chandu (215k points)

0 votes

0 answers

The total extension of the bar loaded as shown in the figure is

asked Dec 25, 2017 in som by chandu (215k points)

0 votes

0 answers

The stretch in a steel rod of circular section,

asked Dec 25, 2017 in som by chandu (215k points)

0 votes

0 answers

In APT language, the cutter motion in incremental coordinate mode is addressed as

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following characteristics of production jobs

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List – I (A function connected with NC m/c tool) with List – II (Associated parameter)

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

If the diameter of the hole is subject to considerable variation, then for locating in

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List – I (Task) with List – II (Recommendation)

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

While cutting helical gears on a non – differential gear hobber, the feed change gear ratio is

asked Dec 23, 2017 in production by chandu (215k points)

Recent questions tagged 1995

Categories

Most popular tags