Recent questions tagged 1993

0 votes

0 answers

Match List I(Cutting tool material) with List II(Major characteristic constituent)

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In ASA system, if the tool nomenclature is 8-6-5-10-15-2-mm, then the side rake angle will be

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

For achieving a specific surface finish in single point turning, the most important factor to be controlled is

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Tool life in the case of a grinding wheel is the time

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

If the chip-tool contact length is reduced slightly by grinding the tool face, then

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Direct extrusion requires larger than indirect extrusion

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List I (Match, property) with List II (related to)

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of the following manufacturing process requires the provision of ‘gutters’?

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

The blank diameter used in thread rolling will be

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

In order to get uniform thickness of the plate by rolling process, one provides

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Tandem drawing of wires and tubes is necessary because

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

In sheet metal work, the cutting force on the tool can be reduced by

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

A moving mandrel is used in

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

The spring stiffness will be

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The modulus of elasticity of the wire be

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The following data refers to an open belt drive

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In gears, interference takes place when

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

A friction circle is drawn when a journal rotates in bearing. Its radius depends on the coefficient of friction and the

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In the assembly of pulley, key and shaft

asked Dec 20, 2017 in md by chandu (215k points)

Page:

« prev
1
2
3
4
5
6
7
8
...
11
next »

...