Recent questions tagged 1990

0 votes

0 answers

Thermosetting plastic

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

Green strength in powder metallurgy refers to the strength of

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

PVC sheets are produced by

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

The following property of a crystalline material depends on crystal defects

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

Plain carbon steel

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

three dimensional state of stress point

asked Aug 15, 2017 in SOM by chandu (215k points)

0 votes

0 answers

Find the required value of F2

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

1 answer

composition of 1% plain carbon steel after cooling from molten state to 740 C

asked Aug 12, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

machines used for small lot production of T-slots

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

equation of longitudinal feed in center-less grinding

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

Calculate the batch size which justified the use of turret lathe

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

find rake and clearance angle, diameter of the job at which tool will start rubbing

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

Calculate chip velocity and total power consumption

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

Calculation of shear angle for theoretically minimum possible shear strain

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

Assertion - Reason : Diamond tools

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

Composition of super HSS tools

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

metal cutting heat goes into

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

Estimating the required no.of electrodes in manual metal arc welding

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

mode of metal transfer in CO2-MIG welding

asked Aug 8, 2017 in production by chandu (215k points)

Page:

« prev
1
2
3
4
5
next »

...