Recent questions tagged 1989

0 votes

0 answers

If the ratio of speed reduction in this unit is 10:1 the efficiency is about

asked Sep 5, 2017 in MD by chandu (215k points)

0 votes

0 answers

Modern gear tooth profile is given involute shape because

asked Sep 5, 2017 in MD by chandu (215k points)

0 votes

0 answers

Stress concentration in a machine component of a ductile material is not so harmful as it is in a brittle material

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

Calculate the clearance volumetric efficiency and the actual volumetric efficiency of the compressor.

asked Sep 2, 2017 in TD by chandu (215k points)

0 votes

0 answers

In a gas turbine power plant intercoolers are used to cool the ------------- (hot gases / compressed air)

asked Sep 1, 2017 in TD by chandu (215k points)

0 votes

0 answers

The current level of the maximum temperature at steam turbine inlet is much lower than that at Gas turbine .......

asked Sep 1, 2017 in TD by chandu (215k points)

0 votes

0 answers

The layout of a steam power plant working on the Rankine Cycle with single stage regeneration is shown in figure.

asked Sep 1, 2017 in TD by chandu (215k points)

0 votes

0 answers

02. The fundamental objective of employing the condenser in a steam power plant is to (reduce/increase) the ___

asked Aug 31, 2017 in TD by chandu (215k points)

0 votes

0 answers

An economizer in a steam generator performs the function of:

asked Aug 31, 2017 in TD by chandu (215k points)

0 votes

0 answers

the process on a psychrometric chart.

asked Aug 31, 2017 in TD by chandu (215k points)

0 votes

0 answers

Wet bulb depression, under saturated ambient air conditions:

asked Aug 31, 2017 in TD by chandu (215k points)

0 votes

0 answers

The exhaust gas composition obtained from an Orsat apparatus in a test on a spark ignition engine is as follows:

asked Aug 30, 2017 in TD by chandu (215k points)

0 votes

0 answers

The effect of variable specific heat and dissociation of the working fluid

asked Aug 30, 2017 in TD by chandu (215k points)

0 votes

0 answers

Thermosetting plastics

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

On analysis a piece of steel was found to contain 0.3%C, 12.0%Cr, 12.0%V. It is a ?

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

The temperature required for heating hypereutectoid steel for normalizing

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

Metals which can be plastically deformed very easily have unit cells of

asked Aug 16, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

Bending moment

asked Aug 15, 2017 in SOM by chandu (215k points)

0 votes

0 answers

body subjected to pure torsion

asked Aug 15, 2017 in SOM by chandu (215k points)

0 votes

0 answers

shear stress in the body

asked Aug 15, 2017 in SOM by chandu (215k points)

Recent questions tagged 1989

Categories

Most popular tags