Recent questions in IES Objectives-2

0 votes

0 answers

Match List – I (Bearings) with List – II (Load type)

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Tapered roller bearings are sensitive to the tightening between

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

A Woodruff key is an easily adjustable key.

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The power that can be transmitted by the new shaft is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The bearing loading ratio and life in million revolutions respectively are

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which one of the following statements is correct for the bearing?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

If bearing pressure is 1.4 MPa, the sommerfeld number is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The viscosity of lubricant is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Keys) with List – II (Characteristics)

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which one of the following sets of parameters should be monitored for determining safe operation of journal bearing?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following pairs of types of bearings and applications

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The key shown in the above figure is a

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In a single row deep groove ball bearing, cages are needed to

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which one of the following types of bearings is employed in shafts of gear boxes of automobiles?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Hydrostatic lubrication is more advantageous when compared to hydrodynamic lubrication during starting and stopping the

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

1. Plain bearing 2. Ball bearing 3. Needle bearing 4. Tapered roller bearing

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The shearing area of a key of length

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Machine element) with List – II (Cause of failure)

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following statements. A splined shaft is used for

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In the assembly design of shaft pulley and key the weakest member is

asked Dec 20, 2017 in md by chandu (215k points)

Page:

« prev
1
...
107
108
109
110
111
112
113
114
115
...
142
next »

Recent questions in IES Objectives-2

...