Recent questions in IES Objectives-2

0 votes

0 answers

A cotter joint is used when no relative motion is permitted between the rods joined by the cotter

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The length of the belt in the case of a cross-belt drive is given in terms of

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The maximum power can be transmitted when the centrifugal tension is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List –I (Coupling) with List –II (Purpose) codes given below this:

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

which one of the following equations will give the diameter of the spigot?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In design of arms of pulley, in belt drive, the cross – section of the arm is elliptical with minor axis placed

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

For similar materials having the same maximum permissible tensile, V – belt transmits more power than

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The creep in a belt drive is due to the

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Which one of the following statements with regard to belt drives is NOT correct?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following stresses are associated with the design of pins in bushed pin – type, flexible coupling?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Application) with List – II (Drive element)

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Different type of detachable joints) with List – II (Specific use of these detachable joints)

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Centrifugal tension in belts is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following stresses are associated with design of pins in bushed pin – type flexible coupling?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

When the shafts are neither parallel nor intersecting, power can be transmitted by using

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The initial tension of the belt taking centrifugal tension is equal to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

the belt would tend hang clear of the lower pulley when

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The virtual coefficient of friction will

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

It is desirable to increase the length of arc over which the oil film has to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

When belt drive is transmitting maximum power

asked Dec 21, 2017 in md by chandu (215k points)

Page:

« prev
1
...
99
100
101
102
103
104
105
106
107
...
142
next »

Recent questions in IES Objectives-2

...