Recent questions in IES Objectives-2

0 votes

1 answer

In centreless grinding, the work piece centre will be

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statement s about the reamer size:

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Internal gears can be made by

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Climb miling is chosen while machining because

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The main purpose of boring operation, as compared to drilling is to:

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The speed of the lead screw will be

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

1. Grinding wheel diameter 2. Regulating wheel diameter

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Tool wear is expressed in terms of flank wear rather than

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

No separate feed motion is

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

For a negative rake tool, the specific cutting pressure is smaller than that for

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

A ‘Dynamometer’ is a device used for the measurement of

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List I(Cutting tool material) with List II(Major characteristic constituent)

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In ASA system, if the tool nomenclature is 8-6-5-10-15-2-mm, then the side rake angle will be

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

For achieving a specific surface finish in single point turning, the most important factor to be controlled is

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Tool life in the case of a grinding wheel is the time

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

If the chip-tool contact length is reduced slightly by grinding the tool face, then

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In gear hobbing

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Gear burnishing is process for

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Gear lapping

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Tail stock set over method of taper turning is preferred for

asked Dec 23, 2017 in production by chandu (215k points)

Recent questions in IES Objectives-2

Categories

Most popular tags