Recent questions in IES Objectives-2

0 votes

0 answers

Fracture surface of grey cast iron is

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

Process capability of machine is defined as the capability of the machine to

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

A diamond locating pin is used in jigs and fixtures because

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

When supported on three points, out of the 12 degrees of freedom the number of degrees of freedom arrested in a body is

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The floating position of holding fixture in a rotary transfer device is used to

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Electron beam welding can be carried out in

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which of the above parameters will influence the axial feed rate in centre-less grinding?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statements for down – milling operation:

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The complexity of a jig or a fixture is determined by

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

During the information of chips in machining with a cutting tool, which one of the following relations holds good?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The values of n and C are

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Flank wear occurs mainly on the

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

If the speeds are in geometric progression, then the ratio is

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The cutting speed will be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The cutting force and the approximate value of torque at a spindle run of 120 r.p.m. will respectively be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The feed in face milling for a width of 70 mm with a cutter of 160 mm diameter,

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

A 125 mm long, 10 mm diameter stainless steel rod is being turned to 9mm diameter, 0.5mm depth of cut.

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

A thick lubrication is

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The ceramic tools used in machining of material

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

For cutting multi-start threads, the speed ratio is expressed in terms of the lead of the job thread and lead of

asked Dec 24, 2017 in production by chandu (215k points)

Recent questions in IES Objectives-2

Categories

Most popular tags