Recent questions in IES Objectives-2

0 votes

0 answers

Match List – I (Crystal structure) with List – II (Atomic packing factor)

asked Dec 26, 2017 in material science by chandu (215k points)

0 votes

0 answers

A unit cell of a crystal is shown in given figure. The miller indices of the direction (arrow) shown in the figure is

asked Dec 26, 2017 in material science by chandu (215k points)

0 votes

0 answers

Which of the following properties of a solid are dependent on crystal imperfections?

asked Dec 26, 2017 in material science by chandu (215k points)

0 votes

0 answers

In metals subjected to cold working, strain hardening effect is due to

asked Dec 26, 2017 in material science by chandu (215k points)

0 votes

0 answers

Which of the following is a point imperfection

asked Dec 26, 2017 in material science by chandu (215k points)

0 votes

0 answers

When deformed elastically an then to have this energy recovered upon unloading is

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The cause of the failure is attributed to

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

This property of the material is known as.

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

When stressed under isostress conditions, is

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

An isotropic elastic material is characterized by

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

What is the stress induced in the rod if it is allowed to expand by

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

If the two rods experience equal extensions, the ratio of

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The maximum normal stress on the plane will

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The thrust thereby generated on the clamp

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The State of stress at a point when completely specified enables one to determine the

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

A steel rod of cross-sectional area 10 mm2 is subjected to loads at points P,Q,R and S as shown in the figure below:

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

Tensile strength of CI is much higher than that of

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The equivalent spring stiffness of this new arrangement is equal to

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The stress in the copper rod is

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

The magnitude of load P required to fill up the gap of 0.75 mm is:

asked Dec 26, 2017 in som by chandu (215k points)

Page:

« prev
1
...
56
57
58
59
60
61
62
63
64
...
142
next »

Recent questions in IES Objectives-2

...