Recent questions in production

0 votes

0 answers

Which one of the following statements is correct about an oblique cutting?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statements with reference to grinding wheel characteristics:

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The specific energy is

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding milling machine:

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

If the feed per tooth is 0.1mm, the table speed in mm per minute is

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

What will happen after a few turning passes?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which drill is good for inverted drilling operation?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Then the shear force will be approximately

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

In an orthogonal turning process, the chip thickness = 0.32 mm, feed = 0.2mm/rev. Then the cutting ratio will be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The value of C in Taylor’s tool life equation VTn = C would be equal to:

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The cutting speed of the above turning operation is:

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

A milling operation which involves the use of a combination of

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Gear hobbing is not used if the quantities to be produced are large and require more accurate gear.

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Negative rake angles are preferred on rigid set–ups for interrupted cutting and difficult–to machine materials.

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Vibrations in milling are induced due to

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Honing is an abrading process to remove stock from

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

During orthogonal cutting, an increase in cutting speed causes

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The most important function of the cutting fluid is to

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Tool life increase with increase in

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

In Taylor’s tool life equation VTn = C the constants n and C depend upon n

asked Dec 24, 2017 in production by chandu (215k points)

Recent questions in production

Categories

Most popular tags