Recent questions in IES Conventional-2

0 votes

0 answers

What is effect of V belt over flat belt in transmission? How to avoid slip in flat belt?

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

1 answer

Write short notes on Interference and undercutting in Involute gears.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Find the speed of shaft Y.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine the number of teeth on each wheel of the gear train.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Examine whether the pair will have interference.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Find the minimum number of teeth on the pinion to avoid interference

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Briefly explain the role of idle gears in a simple gear train with the help of neat sketches.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

What is the law of gearing?

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine the minimum amount of stubbing of gear teeth in terms of module which is to be done now for this pinion.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Find suitable numbers of teeth for the gears and pinions

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

What do you understand by backlash in gears? Along which circle is it measured?

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

In a single involute gear already manufactured of the three diameters given below

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which order of reduction of the three drives listed below is preferred?

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

In an epicyclic gear train the number of planets in any row has to be more than one. Do you agree or disagree. Why?

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine the addendum of the teeth of a gear

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Define contact ratio of two mating gears and mention its importance in design of gear drive.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

To what value should the pressure angle be increased in order to eliminate the interference?

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

If the module of the gears is 4 mm, how many teeth are there on each gear?

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Name two situations where worm-worm gear drive is preferred.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine appropriate number of teeth for all the wheels

asked Nov 24, 2017 in tom by chandu (215k points)

Page:

« prev
1
2
3
4
5
6
7
8
9
...
54
next »

Recent questions in IES Conventional-2

...