Recent questions in GATE

0 votes

0 answers

The primary and secondary shear loads on rivet p, respectively are

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The maximum shear stress, in MPa, in bolts A and B respectively are

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The shear strength of the weld materials is equal to 200MPa. The factor of safety is

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

Bolts in the flanged end of pressure vessel are usually pre-tensioned.

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The bolts in a rigid flanged coupling connecting two shafts transmitting power are subjected to

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

If the ratio of the diameter of rivet hole to the pitch of riverts is 0.25, then the tearing Efficiency of the joints is

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

Weldments in fabricated steel beams are designed for

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The factor of safety using modified Goodman criterion is

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The Soderberg’s principle

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The factor of safety against fatigue endurance as per Soderberg’s criterion is

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The factor of safety as per Godman’s relation is

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

If the corrected endurance strength is 70MPa, estimated shaft life will be

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

1 answer

The available factor of safety for this loading is

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

For the given fluctuating fatigue load, the value of stress amplitude and stress ratio are respectively

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

Which one of the following is the most conservative fatigue failure criterion?

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The factor of safety for the shaft is _________

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The value of stress amplitude (in MPa) is ________

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

The S-N curve for steel becomes asymptotic nearly at

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

In terms of theoretical stress concentration factor (kt) and figure stress concentration factor (kf)

asked Sep 4, 2017 in MD by chandu (215k points)

0 votes

0 answers

This shaft will be designed for

asked Sep 4, 2017 in MD by chandu (215k points)

Page:

« prev
1
...
38
39
40
41
42
43
44
45
46
...
102
next »

Recent questions in GATE

...