Recent questions in GATE

0 votes

0 answers

Reason for wear out of the tool

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

calculation of uncut chip thickness

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

calculation of tool life for maximum production

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

calculation of specific cutting pressure

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

minimum shear strain in orthogonal turning with zero rake angle is

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

Friction at the tool – chip interface can be reduced by

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

formation of Built up edge

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

How to avoid formation of built-up edge during machining?

asked Aug 11, 2017 in production by chandu (215k points)

0 votes

0 answers

When BUE will form in machining?

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

metal cutting heat

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

Cutting power consumption in turning can be significantly reduced by

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

effect of rake angle on the mean friction angle in machining

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

metal cutting heat goes into

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

cater wear in tool tip

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

SIze of BUE in metal cutting

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

purpose of cutting fluid for low speed machining

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

1 answer

effect of feed rate and nose radius on surface finish in turning

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

Purpose of large positive rake angle in cutting tools

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

calculate heat used for producing weld nugget and heat dissipated from base metal

asked Aug 10, 2017 in production by chandu (215k points)

0 votes

0 answers

calculate heat input per unit length and area of cross-section of weld bead

asked Aug 10, 2017 in production by chandu (215k points)

Page:

« prev
1
...
86
87
88
89
90
91
92
93
94
...
102
next »

Recent questions in GATE

...